usb3.0 not working

usb3.0 not working

Postby chander » Thu Jun 11, 2015 10:37 am

USB3.0 not detecting usb3.0 devices, sitting on usb3.0 hub connected to usb3.0 port.
But on same usb3.0 port if I connect usb2.0 hub it works.

My question is weather usb3.0 works on board, and tested?
chander
 
Posts: 4
Joined: Sun May 31, 2015 8:53 am

Re: usb3.0 not working

Postby ellab » Mon Jun 15, 2015 2:24 pm

You have to get a usb crossover cable in order to use as host.
For a ultra-high-speed implementation,
you'd better use a usb hub powered from an external power source.
ellab
 
Posts: 4
Joined: Wed Jul 16, 2014 8:04 am

Re: usb3.0 not working

Postby chander » Mon Jun 15, 2015 5:20 pm

I have self powered usb3.0 hub. On to 3.0 hub I have attached the usb3.0 device.
The hub as well as device is not getting detected. Is it working please confirm?
chander
 
Posts: 4
Joined: Sun May 31, 2015 8:53 am

Re: usb3.0 not working

Postby ellab » Tue Jun 16, 2015 3:03 am

I attached the usb3.0 hub using a crossover usb cable.
Please don't forget to supply external power source.

Rex board == crossover 3.0 Rx+-/Tx+- == USB 3.0 Hub
ellab
 
Posts: 4
Joined: Wed Jul 16, 2014 8:04 am


Return to BSP

Who is online

Users browsing this forum: No registered users and 2 guests

cron